Loading...
11 results
Search Results
Now showing 1 - 10 of 11
- Reactivity of syringyl and guaiacyl lignin units and delignification kinetics in the kraft pulping of eucalyptus globulus wood using Py-Gc-Ms/FIDPublication . Lourenço, Ana; Gominho, Jorge; V Marques, A; Pereira, HelenaEucalyptus globulus sapwood and heartwood showed no differences in lignin content (23.0% vs. 23.7%) and composition: syringyl-lignin (17.9% vs. 18.0%) and guaiacyl-lignin (4.8% vs. 5.2%). Delignification kinetics of S- and G-units in heartwood and sapwood was investigated by Py-GC–MS/FID at 130, 150 and 170 °C and modeled as double first-order reactions. Reactivity differences between S and G-units were small during the main pulping phase and the higher reactivity of S over G units was better expressed in the later pulping stage. The residual lignin composition in pulps was different from wood or from samples in the initial delignification stages, with more G and H-units. S/G ratio ranged from 3 to 4.5 when pulp residual lignin was higher than 10%, decreasing rapidly to less than 1. The S/H was initially around 20 (until 15% residual lignin), decreasing to 4 when residual lignin was about 3%.
- Aliphatic bio-oils from corks: a Py-Gc/MS studyPublication . V Marques, A; Pereira, HelenaCork samples from Betula pendula, Quercus suber and Quercus cerris were submitted to Py-GC-MS/FID at temperatures between 550 degrees C and 900 degrees C and the pyrolysis-derived compounds (py-products) were identified and quantified. Corks were compared with wood samples. Py-products include suberin, lignin and carbohydrates derivatives. Suberin py-products are dominated by unsaturated aliphatics. Corks pyrolysis yield and composition were dramatically influenced by temperature in contrast to wood that showed stable results across temperatures. At 850-900 degrees C the peaks area of cork pyrograms were approximately two times higher than at 550 degrees C, for which yield was about half of the woods, and cork py-products were dominated by suberin-derived short chain aliphatics, namely 1-alkenes, while at 550 degrees C composition was dominated by lignin derivatives. Lignin and carbohydrate derived products decreased dramatically over 750 degrees C while the opposite was observed for unsaturated aliphatics. Cork materials show a high potential as feedstock for production of aliphatic-rich pyrolytic biofuels or as a source of olefins. (C) 2014 Elsevier B.V. All rights reserved.
- A methodological approach for the simultaneous quantification of glycerol and fatty acids from cork suberin in a single GC runPublication . V Marques, A; Pereira, HelenaIntroduction: Suberin, as part of plant protective barriers, is one of the most important natural polymers after cellulose and lignin. For a full elucidation of suberin structure the quantification of glycerol, fatty α,ω‐diacids and ω‐hydroxyacids, the major building blocks of suberin, is of primary importance. Glycerol is often lost in the most used analytical procedures or rarely determined by deficient or too laborious techniques. Objectives: Propose a simple, accessible and reliable methanolysis work‐up procedure for an accurate and simultaneous quantification of glycerol and suberin fatty monomers in the same GC run. Material and methods: Cork from Quercus suber L. was depolymerised by methanolysis. Glycerol was derivatised to an organic soluble form before the suberin monomers recovery in water/organic solvent partition. Gas chromatography flame ionisation detector (GC‐FID) response factors were determined for glycerol, ferulic acid and one for each fatty monomer substructure. Additionally, 1,2,4‐butanetriol and methyl nonadecanoate were used as internal standards. Results: The proposed experimental approach allowed the glycerol and all the fatty suberin monomers in the same GC run to be quantified accurately. Glycerol represented 30.6 area%, 14.2 mass% and 38.4 molar% of suberin and the COOH/OH groups ratio was 0.6:1 in the proposed experimental approach in contrast with 0.10 area% and COOH/OH ratio of 3:1 in the most used protocol. Furthermore, ω‐hydroxyacids/α,ω‐diacids mass ratio was 1:1 as opposed to an area ratio of 1.5:1. Conclusion: The proposed work‐up procedure revealed to be a reliable analytical tool for the complete analysis of suberin allowing the future knowledge to grow towards a better understanding of suberin structure throughout its range and variability.
- The identification of new triterpenoids in eucalyptus globulus woodPublication . Lourenço, Ana; V Marques, A; Gominho, JorgeEight polyhydroxy triterpenoid acids, hederagenin, (4α)-23-hydroxybetulinic acid, maslinic acid, corosolic acid, arjunolic acid, asiatic acid, caulophyllogenin, and madecassic acid, with 2, 3, and 4 hydroxyl substituents, were identified and quantified in the dichloromethane extract of Eucalyptus globulus wood by comparing their GC-retention time and mass spectra with standards. Two other triterpenoid acids were tentatively identified by analyzing their mass spectra, as (2α)-2- hydroxybetulinic acid and (2α,4α)-2,23-dihydroxybetulinic acid, with 2 and 3 hydroxyl substituents. Two MS detectors were used, a quadrupole ion trap (QIT) and a quadrupole mass filter (QMF). The EI fragmentation pattern of the trimethylsilylated polyhydroxy structures of these triterpenoid acids is characterized by the sequential loss of the trimethylsilylated hydroxyl groups, most of them by the retro-Diels-Alder (rDA) opening of the C ring with a π-bond at C12-C13. The rDA C-ring opening produces ions at m/z 320 (or 318) and m/z 278 (or 277, 276, 366). Sequential losses of the hydroxyl groups produce ions with m/z from [M - 90] to [M - 90*y], where y is the number of hydroxyl substituents present (from 2 to 4). Moreover, specific cleavage in ring E was observed, passing from m/z 203 to m/z 133 and conducting other major fragments such as m/z 189.
- Ferulates and lignin structural composition in corkPublication . V Marques, A; RENCORET, JORGE; Gutiérrez, Ana; Río, José C. del; Pereira, HelenaThe structure of lignin and suberin, and ferulic acid (FA) content in cork from Quercus suber L. were studied. Extractive-free cork (Cork), suberin, desuberized cork (Cork(sap)), and milled-cork lignins (MCL) from Cork and Cork(sap) were isolated. Suberin composition was determined by GC-MS/FID, whereas the polymers structure in Cork, Corksap, and MCL was studied by Py-TMAH and 2D-HSQC-NMR. Suberin contained 94.4% of aliphatics and 3.2% of phenolics, with 90% of omega-hydroxyacids and alpha,omega-diacids. FA represented 2.7% of the suberin monomers, overwhelmingly esterified to the cork matrix. Py-TMAH revealed significant FA amounts in all samples, with about 3% and 6% in cork and cork lignins, respectively. Py-TMAH and 2D-HSQC-NMR demonstrated that cork lignin is a G-lignin (>96% G units), with a structure dominated by beta-O-4' alkyl-aryl ether linkages (80% and 77% of all linkages in MCL and MCLsap, respectively), followed by phenylcoumarans (18% and 20% in MCL and MCLsap, respectively), and smaller amounts of resinols (ca. 2%) and dibenzodioxocins (1%). HSQC also revealed that cork lignin is heavily acylated (ca. 50%) exclusively at the side-chain gamma-position. Ferulates possibly have an important function in the chemical assembly of cork cell walls with a cross-linking role between suberin, lignin and carbohydrates.
- Py-GC/MS(FID) assessed behavior of polysaccharides during kraft delignification of Eucalyptus globulus heartwood and sapwoodPublication . Lourenço, Ana; Gominho, Jorge; V Marques, A; Pereira, HelenaEucalyptus globulus heartwood, sapwood and their delignified samples by kraft pulping at 130, 150 and 170 degrees C along time were characterized in respect to total carbohydrates by Py-GC/MS(FID). No significant differences between heartwood and sapwood were found in relation to pyrolysis products and composition. The main wood carbohydrate derived pyrolysis compounds were levoglucosan (25.1%), hydroxyacetaldehyde (12.5%), 2-oxo-propanal (10.3%) and acetic acid (8.7%). Levoglucosan decreased during the early stages of delignification and increased during the bulk and residual phases. Acetic acid decreased hydroxyacetaldehyde and 2-oxo-propanal increased, and 2-furaldehyde and hydroxypropanone remained almost constant during delignification. The C/L ratio was 3.2 in wood and remained rather constant in the first pulping periods until a loss of 15-25% in carbohydrate and 60% in lignin. Afterwards it increased sharply until 44 that correspond to the removal of 25-35% of carbohydrates and 95% of lignin. The pulping reactive selectivity to lignin vs. polysaccharides was the same for sapwood and heartwood. (C) 2013 Elsevier B.V. All rights reserved.
- An extensive study on the chemical diversity of lipophilic extractives from Eucalyptus globulus woodPublication . Gominho, Jorge; Lourenço, Ana; Marques, António Velez; Pereira, HelenaThree mature Eucalyptus globulus trees with 40 years of age were studied at three height levels (0%, 35%, and 60% of total tree height) and at three radial regions (sapwood, inner and outer heartwood). The composition of lipophilic extracts was evaluated and an extensive list of 202 compounds was reported for the first time. The fatty acids were the major chemical family, representing 40.8% of the total compounds, followed by phytosterols (19.0%), aromatics (10.5%) and triterpenes (10.4%). Saturated fatty acids accounted for 74.2% of total compounds (C-16(:0), C-24(:0) and C-26(:0) were predominant), beta-Sitosteml and stigmastanol were the main sterols (80 and 7% respectively), while aromatics were mainly represented by syringic acid, 4-hydroxy-3,5-dimethoxybenzaldehyde, vanillic acid, and vanillin. The main triterpenes were asiatic and arjunolic acids.
- Biomass production of four Cynara cardunculus clones and lignin composition analysisPublication . Lourenço, Ana; Neiva, Duarte Miranda; Gominho, Jorge; Curt, María Dolores; Fernández, Jesús; V Marques, A; Pereira, HelenaFour Cynara cardunculus clones, two from Portugal and two from Spain were studied for biomass production and their lignin was characterized. The clones differed in biomass partitioning: Spanish clones produced more capitula (54.5% vs. 43.9%), and Portuguese clones more stalks (37.2% vs. 25.6%). The heating values (HHV0) of the stalks were similar, ranging from 17.1 to 18.4 MJ/kg. Lignin was studied by analytical pyrolysis (Py-GC/MS(FID)), separately in depithed stalks (stalksDP) and pith. StalksDP had in average higher relative proportions of lignin derived compounds than pith (23.9% vs. 21.8%) with slightly different lignin monomeric composition: pith samples were richer in syringyl units as compared to stalksDP (64% vs. 53%), with S/G ratios of 2.1 and 1.3, respectively. The H:G:S composition was 7:40:53 in stalksDP and 7:29:64 in pith. The lignin content ranged from 18.8% to 25.5%, enabling a differentiation between clones and provenances. © 2015 Elsevier Ltd. All rights reserved.
- Study of thermochemical treatments of cork in the 150-400ºC range using colour analysis and Ftir spectroscopyPublication . Sem, Ali; V Marques, A; Gominho, Jorge; Pereira, HelenaA study of chemical transformations of cork during heat treatments was made using colour variation and FTIR analysis. The cork enriched fractions from Quercus cerris bark were subjected to isothermal heating in the temperature range 150–400 ◦C and treatment time from 5 to 90 min. Mass loss ranged from 3% (90 min at 150 ◦C) to 71% (60 min at 350 ◦C). FTIR showed that hemicelluloses were thermally degraded first while suberin remained as the most heat resistant component. The change of CIE-Lab parameters was rapid for low intensity treatments where no significant mass loss occurred (at 150 ◦C L* decreased from the initial 51.5 to 37.3 after 20 min). The decrease in all colour parameters continued with temperature until they remained substantially constant with over 40% mass loss. Modelling of the thermally induced mass loss could be made using colour analysis. This is applicable to monitoring the production of heat expanded insulation agglomerates.
- Chemical composition and antioxidante activity of Tunisian Origanum glandulosum Desf. essential oil and volatile oil obtain by supercritical CO2 extractionPublication . Mechergui, Kaouther; Jaouadi, Wahbi; Coelho, Jose; Serra, Maria Celeste; V Marques, A; Palavra, António M. F.; Khouja, Mohamed Larbi Arbi; BOUKHCHINA, SADOKDried flowers and leaves of Origanum glandulosum Desf. were submitted to hydrodistillation (HD) and supercritical fluid extraction with CO2 (SFE). The essential oils isolated by HD and volatile oils obtained by SFE were analysed by GC and GC/MS. Total phenolics content and antioxidant effectiveness were performed. The main components of the essential oils from Bargou and Nefza were: p-cymene (40.4% and 39%), thymol (38.7% and 34.4%) and γ- terpinene (12.3% and 19.2%), respectively. The major components obtain by SFE in the volatile oil, from Bargou and Nefza, were: p-cymene (32.3% and 36.2%), thymol (41% and 40%) and γ-terpinene (20.3% and 13.3%). Total phenolic content, expressed in gallic acid equivalent (GAE) g kg-1 dry weight, varied from 12 to 27 g kg-1 dw, and the ability to scavenge the DPPH radicals, expressed by IC50 ranged from 44 to143 mg L-1.