Browsing by Author "Fantoni, Alessandro"
Now showing 1 - 10 of 92
Results Per Page
Sort Options
- A 3-phase model for VIS/NIR mu C-Si : H p-i-n detectorsPublication . Vieira, Manuela; Fantoni, Alessandro; Fernandes, Miguel; Maçarico, António Filipe Ruas Trindade; Schwarz, R.The spectral response and the photocurrent delivered by entirely microcrystalline p-i-n-Si:H detectors an analysed under different applied bias and light illumination conditions. The spectral response and the internal collection depend not only on the energy range but also on the illumination side. Under [p]- and [n]-side irradiation, the internal collection characteristics have an atypical shape. It is high for applied bias and lower than the open circuit voltage, shows a steep decrease near the open circuit voltage (higher under [n]-side illumination) and levels off for higher voltages. Additionally, the numerical modeling of the VIS/NIR detector, based on the band discontinuities near the grain boundaries and interfaces, complements the study and gives insight into the internal physical process.
- a-SiCH based devices as optical demultiplexersPublication . Louro, Paula; Vieira, Manuela; Costa, João; Vieira, Manuel; Fernandes, Miguel; Fantoni, Alessandro; Barata, ManuelIn this paper we present results on the use of a multilayered a-SiC:H heterostructure as a wavelength-division demultiplexing device (WDM) for the visible light spectrum. The WDM device is a glass/ITO/a-SiC:H (p-i-n)/ a-SiC:H(-p) /Si:H(-i)/SiC:H (-n)/ITO heterostructure in which the generated photocurrent at different values of the applied bias can be assigned to the different optical signals. The device was characterized through spectral response measurements, under different electrical bias. Demonstration of the device functionality for WDM applications was done with three different input channels covering wavelengths within the visible range. The recovery of the input channels is explained using the photocurrent spectral dependence on the applied voltage. The influence of the optical power density was also analysed. An electrical model, supported by a numerical simulation explains the device operation. Short range optical communications constitute the major application field, however other applications are also foreseen.
- a-SiH p-i-n structures with extreme i-layer thicknessPublication . Fantoni, Alessandro; Fernandes, Miguel; Vieira, Manuela; Casteleiro, C.; Schwarz, R.We present measurements and numerical simulation of a-Si:H p-i-n detectors with a wide range of intrinsic layer thickness between 2 and 10 pm. Such a large active layer thickness is required in applications like elementary particle detectors or X-ray detectors. For large thickness and depending on the applied bias, we observe a sharp peak in the spectral response in the red region near 700 nm. Simulation results obtained with the program ASCA are in agreement with the measurement and permit the explanation of the experimental data. In thick samples holes recombine or are trapped before reaching the contacts, and the conduction mechanism is fully electron dominated. As a consequence, the peak position in the spectral response is located near the optical band gap of the a-Si:H i-layer. (C) 2009 Elsevier B.V. All rights reserved.
- Add/drop filters based on SiC technology for optical interconnectsPublication . Vieira, Manuela; Vieira, Manuel; Louro, Paula; Fantoni, Alessandro; Silva, VítorIn this paper we demonstrate an add/drop filter based on SiC technology. Tailoring of the channel bandwidth and wavelength is experimentally demonstrated. The concept is extended to implement a 1 by 4 wavelength division multiplexer with channel separation in the visible range. The device consists of a p-i'(a-SiC:H)-n/p-i(a-Si: H)-n heterostructure. Several monochromatic pulsed lights, separately or in a polychromatic mixture illuminated the device. Independent tuning of each channel is performed by steady state violet bias superimposed either from the front and back sides. Results show that, front background enhances the light-to-dark sensitivity of the long and medium wavelength channels and quench strongly the others. Back violet background has the opposite behaviour. This nonlinearity provides the possibility for selective removal or addition of wavelengths. An optoelectronic model is presented and explains the light filtering properties of the add/drop filter, under different optical bias conditions.
- An indium-oxide electrode with discontinuous Au layers for plasmonic devicesPublication . Vygranenko, Yuri; Lavareda, G.; André, V.; Brogueira, Pedro; Amaral, A.; Fernandes, M.; Fantoni, Alessandro; Vieira, ManuelaIn this contribution we report on a low cost plasmonic electrode for light-sensing applications. The electrode combines a conducting nonstoichiometric indium oxide (InOx) layer with an ultrathin (~5 nm) discontinuous Au layer. The InOx and Au layers were deposited on glass substrates by plasma enhanced reactive thermal evaporation and thermal evaporation, respectively. Several device configurations with one or two Au layer(s) sandwiched between InOx layers were fabricated and characterized. The morphological and structural properties of both Au and InOx layers were analyzed using AFM and XRD techniques. In particular, the effect of thermal annealing (673 K, 15 min) on the surface morphology of Au layers grown on bare glass and InOx-coated substrate was investigated. It has been also found that the oxide film grown above an underlying nanostructured Au layer is amorphous, while a reference InOx film on glass is nanocrystalline with a smooth surface. The electrical properties of InOx grown on the Au surface are worsened due to Au-induced structural disorder. The observed difference in transmission spectra of the glass/InOx/Au and glass/Au/InOx structures indicates the difference in the morphology of the metal layer. Thus, the optical and morphological properties of the InOx electrode can be varied in a wide range by incorporating several Au layers.
- Analysis and simulation of a-Si Ha-SiC HPINIP structures for color image detectionPublication . Fantoni, Alessandro; Fernandes, Miguel; Vygranenko, Yuri; Vieira, ManuelaIt is presented in this paper a study on the photo-electronic properties of multi layer a-Si: H/a-SiC: H p-i-n-i-p structures. This study is aimed to give an insight into the internal electrical characteristics of such a structure in thermal equilibrium, under applied Was and under different illumination condition. Taking advantage of this insight it is possible to establish a relation among-the electrical behavior of the structure the structure geometry (i.e. thickness of the light absorbing intrinsic layers and of the internal n-layer) and the composition of the layers (i.e. optical bandgap controlled through percentage of carbon dilution in the a-Si1-xCx: H layers). Showing an optical gain for low incident light power controllable by means of externally applied bias or structure composition, these structures are quite attractive for photo-sensing device applications, like color sensors and large area color image detector. An analysis based on numerical ASCA simulations is presented for describing the behavior of different configurations of the device and compared with experimental measurements (spectral response and current-voltage characteristic). (c) 2008 WILEY-VCH Verlag GmbH & Co. KGaA, Weinheim.
- Analysis of metallic nanoparticles embedded in thin film semiconductors for optoelectronic applicationsPublication . Fantoni, Alessandro; Fernandes, Miguel; Vygranenko, Yuri; Louro, Paula; Vieira, Manuela; Silva, R. P. O.; Teixeira, D.; Da Costa Ribeiro, Ana Paula; Prazeres, Duarte; Alegria, ElisabeteThis paper reports about a study of the local plasmonic resonance (LSPR) produced by metal nanoparticles embedded in a dielectric or semiconductor matrix. It is presented an analysis of the LSPR for different nanoparticle metals, shapes, and embedding media composition. Metals of interest for nanoparticle composition are Aluminum and Gold. Shapes of interest are nanospheres and nanotriangles. We study in this work the optical properties of metal nanoparticles diluted in water or embedded in amorphous silicon, ITO and ZnO as a function of size, aspect-ratio and metal type. Following the analysis based on the exact solution of the Mie theory and DDSCAT numerical simulations, it is presented a comparison with experimental measurements realized with arrays of metal nanospheres. Simulations are also compared with the LSPR produced by gold nanotriangles (Au NTs) that were chemically produced and characterized by microscope and optical measurements.
- Applications for a-Si:H TFTs: modelling and simulationPublication . Lourenço, P.; Fantoni, Alessandro; Fernandes, M.; Costa, J.; Vieira, ManuelaHydrogenated amorphous silicon thin film transistors have been used as switching elements in liquid crystal displays and large area matrix addressed sensor arrays. Later, these devices have also been used as analogue active elements in organic light emitting diode displays. However, this technology suffers from bias induced meta-stability. This issue introduces both threshold voltage and subthreshold slope shifts over time when gate bias is applied. Such instabilities jeopardize long term performance of circuits that rely on these components. Nevertheless, hydrogenated amorphous silicon thin film transistors present an exponential transfer characteristic when operating on subthreshold region and their typical power consumption is under 1 µW. This low power characteristic makes these devices ideally suited for low power electronic design. This work demonstrates, through transient analysis of a wellestablished simulation model for hydrogenated amorphous silicon, the viability of thin film transistors technology to perform both analogue and digital functions. Hence, these structures may be used in both application fields. To this end, two different sets of analyses have been conducted with hydrogenated amorphous silicon based thin film transistors. The first set considers a driving circuit for an active matrix of organic light emitting diodes, biased in a way to minimize the “memory effect” (increasing shift on threshold voltage) due to long term operation. The second set of analyses were conducted upon the implementation of complementary output universal gates, namely NOR/OR and XNOR/XOR elements.
- Arrayed graphene enhanced surface plasmon resonance for sensing applicationsPublication . Fantoni, Alessandro; Vygranenko, Yuri; Maçarico, António; Serafinelli, Caterina; Fernandes, Miguel; Mansour, Rima; Jesus, Rui; Vieira, ManuelaCombination of carbon-based nanomaterials (CNMs) with AuNPs has been demonstrated to enhance the LSPR response and facilitate the functionalization with specific and selective antibodies. Also, the introduction of CNMs in the plasmonic layer allows tuning of the LSPR central frequency. Joining the double dependence of the LSPR on the MNPs size and the presence of CNMs, it is possible to create a set of plasmonic layers whose LSPR wavelengths are distributed in a spectral range of few tenth of nanometers. This consideration paves the way to an LSPR sensor with an arrayed structure, where each element maximizes its specific LSPR at its own wavelength. Illumination with a broad light source produces a different response in each one of the elements. The working process underlying the sensing operation is that each element of the sensor array acts like a band-stop optical filter for a specific wavelength. The output can be extracted by the application of an image analysis approach to the spatially modulated light crossing the sensor area, based on a color recognition algorithm. A change in the refractive index over the sensor array will shift the rejection band of the sensing elements. An automatized method for color recognition can support the analysis of the refractive index variations yielding the final sensor output. A figure of merit, highlighting the LSPR central wavelength and spectral extension for different LSPR configurations, is also obtained for different sizes of the AuNPs and different flavors of CNMs.
- Bi-directional VLC LED-assisted navigation system for large indoor environmentsPublication . Vieira, Manuela; Vieira, Manuel; Louro, Paula; Fantoni, Alessandro; Vieira, PedroIn this paper, a LED-assisted positioning and navigation VLC system is proposed. A VLC scenario for large environments is stablished, the emitters and receivers are characterized and the communication protocol presented. Different layouts are analyzed. Square and hexagonal meshes are tested and a 2D localization design, demonstrated by a prototype implementation, is presented. The key differences between both topologies are discussed. For both, the transmitted information, indoor position, motion direction as well as bi-directional communication are determined. The results showed that the LED-aided VLC navigation system make possible to determine the position of a mobile target inside the network, to infer the travel direction along the time and to interact with information received.