Loading...
4 results
Search Results
Now showing 1 - 4 of 4
- Using power electronics and automation to simulate solar PV systemsPublication . Fonte, Pedro M.; Cordeiro, Armando; Barata, Filipe; Pires, V. Fernão; Chaves, Miguel; Foito, Daniel; Gamboa, PauloThis paper presents a solar photovoltaic panel simulator system with the ability to perform automatic tests in different condition according to manufacture parameters. This simulator is based on three buck--boost DC -DC converters controlled by a microcontroller and supported by a AXC 1050 Programmable Logic Controller from Phoenix Contact which is responsible for running the automatic tests. This solution allows to understand the typical operation of solar photovoltaic panels and MPPT algorithms considering suddenly changes in the irradiation, temperature, or load.
- Novel design of the converter for an active UPS application based on Marx modulator concept with supercapacitorsPublication . Pestana, Celso; Canacsinh, Hiren; Chaves, Miguel; Gamboa, Paulo; Cordeiro, Armando; Luís, Ricardo; Martins, Ana Alexandra; Encarnação, Luís; Pereira, Fernando; Silva, José Fernando; Santos, NunoA new Marx modulator 4-leg multilevel converter is proposed to replace the well-known 4-leg inverter fed from batteries in Uninterruptible Power Supply (UPS) applications. The novel design concept for the Marx modulator based multilevel converter is presented and described. Each leg uses 2 Marx modulator modules, each one using an Electrochemical Double-Layer Capacitor (EDLC) (also known as supercapacitor (SC)) energy storage bank. The new topology concept enables multilevel operation with five voltage level per phase, allowing high quality voltage and current waveforms, distributed supercapacitor storage and reduction of supercapacitor bank voltage. The proposed converter can operate as UPS or as Active Power Filter (APF), powering non-linear or/and unbalanced loads, while balancing each leg supercapacitor voltage. A control strategy to choose the redundant vector configuration to balance the supercapacitor voltages is explained. Simulation results are presented for a Marx modulator based interactive 40 kVA UPS.
- Combining power electronic converters and automation to simulate solar PV systemsPublication . Cordeiro, Armando; Chaves, Miguel; Gamboa, Paulo; Barata, Filipe; Fonte, Pedro M; Lopes, Hélio; Fernao Pires, Vitor; Foito, Daniel; Amaral, Tito; Martins, JoaoThis paper presents a solar photovoltaic panel simulator system with the ability to perform automatic tests in different condition according to manufacture parameters. This simulator is based on three buck-boost DC-DC converters controlled by a microcontroller and supported by a Programmable Logic Controller which is responsible for the automatic tests. This solution will allow to achieve fast response, like suddenly changes in the irradiation, temperature, or load. To control the power converter, it will be used a fast and robust sliding mode controller. Therefore, with the proposed system is possible to perform the I-V curve simulation of a solar PV panel, evaluate different MPPT algorithms considering different meteorological and load variation. The main advantage of this work is the possibility to evaluate and test several MPPT algorithms and understand the operation and typical operation of solar PV panels in different conditions. Several simulations and experimental results from a laboratory prototype are presented to confirm the theoretical operation.
- Transformerless ultra-high gain buck-boost DC-DC converter with single-switch of reduced voltage stressPublication . Cordeiro, Armando; Gamboa, Paulo; Luís, Ricardo; Fonte, Pedro M; Monteiro, Joaquim; Martins, João F.; Silva, J. Fernando; Foito, Daniel; Fernao Pires, VitorThis paper introduces a new DC-DC power converter topology capable of both step-up and step-down voltage conversion, with an exceptionally high voltage gain ratio.. Besides the high extension of the voltage gain range, the converter is also characterized by the use of a single switch. Moreover, the stress imposed on the switch's voltage is minimized, enabling the utilization of low-voltage, low RDS-ON MOSFETs. Consequently, this modification leads to reduced costs and losses associated with switch conduction and turn ON. Another aspect concerning the proposed converter is that the input current exhibits a continuous behavior, which can be significant for various applications. The paper provides insights into the operational performance, steady state behavior, and mathematical underpinnings of the proposed dc-dc converter. Comparative evaluation of the static voltage gain of the proposed converter and other topologies with comparable characteristics will also be shown. Verification of the presented converter's key features are conducted through both simulation and experimental assessments using a 440-W laboratory prototype. Through these analyses, the efficacy and viability of the modified coupled-inductor SEPIC converter with enhanced voltage gain capability are confirmed.