Loading...
2 results
Search Results
Now showing 1 - 2 of 2
- Experimental study of an onshore dual chamber oscillating water column devicePublication . Gadelho, Jorge; Rezanejad, Kourosh; Guedes Soares, Carlos; Santos, João Alfredo; Anastas, Gael; Fortes, ConceiçãoA wave flume is used to study a scaled model of a stepped bottom dual-chamber Oscillating Water Column (OWC) installed onshore. Compared to traditional single-chamber OWCs, the use of dual-chambers is expected to widen the range of sea states in which the OWC is more efficient, and the step, in front of the first chamber, boosts the capturing energy capacity of the device. The Power Take-Off (PTO) system is modelled as an air opening in the pneumatic chambers. Several experiments combining regular incident waves and PTO damping conditions are performed. Results of the amplitudes of the free surface elevations inside the chambers show that the device can amplify the incident wave amplitude up to 1.57 times in chamber 2. Results of the primary ef ficiency show that the device is highly dependent on the PTO damping characteristics and can reach around 40% for a wide range of wave periods. Results of the reflection analysis show that the reflection coefficient is also dependent on the PTO damping characteristics but remain lower than 0.6 for all the studied cases. Sloshing phenomenon (mostly in the cross-section direction) was observed for a wavelength close to the cross-section dimension, impacting negatively on the device pneumatic performance.
- Physical modelling of motions and forces on a moored ship at the Leixões portPublication . Santos, João Alfredo; Pinheiro, Liliana; Abdelwahab, Hossam S.; Fortes, Conceição; Pedro, Francisco G. L.; Capitão, Rui P.; Hinostroza, Miguel; Soares, Carlos GuedesThis paper describes the physical model, experimental setup and tests performed at the Portuguese Civil Engineering Laboratory (LNEC), to study the motions and forces of a moored ship at the Leixões port, for different sea states in irregular waves. The tests were carried out at one of the wave tanks of LNEC, where the Leixões port layout was implemented at scale 1:80 with the detailed model similar to the prototype bathymetry and surrounding structures. The moored ship is a 3.43 m long scale model of the well-known “Esso Osaka” tanker and is moored to the pier A of the oil terminal at 0.135 m draft. Several types of measurements were recorded in this study. The freesurface elevation and wave direction were measured with a set of resistive wave gauges. The wave velocities at the entrance of the harbour were measured with an acoustic Doppler velocimeter. Motions of the moored ship were measured with the OptiTrack™ motion capture system whereas forces on fenders and mooring lines were measured with load cells attached to a complex spring system developed at LNEC. Several tests were carried out for a number of incident sea states characterized by a JONSWAP spectrum, with different significant wave heights and peak periods. The measurement, analysis and results obtained for the incident wave conditions characterized by a significant wave height of 6 m and a peak wave period of 14 s are presented and discussed in this paper.