Percorrer por autor "Pires, V. Fernão"
A mostrar 1 - 3 de 3
Resultados por página
Opções de ordenação
- Bidirectional boost/buck quadratic converter for distributed generation systems with electrochemical storage systemsPublication . Pires, V. Fernão; Foito, D.; Cordeiro, ArmandoThe increasing number of distributed generation systems using renewable and non-conventional energy sources show the trend of future generation systems. Most of these systems require power electronic converters as an interface between the DC voltage buses and electrochemical storage systems. Such storage systems, like batteries or supercapacitors, usually need bidirectional DC-DC converters to allow their charge or discharge according with necessary operation conditions. In this paper, a non-isolated bidirectional Buck-Boost converter with high voltage gain for electrochemical storage devices used in distributed generation systems is presented. To achieve high voltage gain ratios, the proposed topology presents quadratic characteristics in both step-down (Buck) and step-up (Boost) operation modes. In addition to the wide conversion range, it presents continuous input and output current, reduced charging/discharging ripple and simple control circuitry. All these features allow the energy exchange smoothly and continuously resulting in a longer durability of storage devices. The principle of the operation of the proposed converter in both operation modes, as well as their theoretical analysis will be discussed. The performance of this bidirectional power converter is confirmed through simulation and experimental results.
- Multilevel inverter based on a dual two-level nine-switch converter for a dual three-phase or six-phase motor drive systemPublication . Pires, V. Fernão; Cordeiro, Armando; Foito, Daniel; Pires, A. J.; Silva, J. Fernando A.; Chen, HaoThe nine-switch inverter is considered as a very interesting solution for three-phase dual output applications, such as dual three-phase or six-phase motor drive systems. The main advantage of this approach is a converter topology with a reduced number of power semiconductors. However, the AC output voltages are limited to only two levels. This work proposes a new inverter topology for dual three-phase or six-phase motor drive systems with multilevel output characteristics. The proposed topology is based on two isolated inverters, but the number of legs is reduced from six to three. This structure creates a modular multilevel inverter with a high number of voltage levels while using a comparatively smaller number of power semiconductors. A modulation strategy, associated with the proposed topology, is presented to ensure multilevel operation. The proposed topology and modulation strategy will be tested first through a simulation in Matlab/Simulink and then by laboratory tests using an experimental prototype. The obtained results show a good agreement between simulations and experiments, both confirming the theoretical studies.
- Using power electronics and automation to simulate solar PV systemsPublication . Fonte, Pedro M.; Cordeiro, Armando; Barata, Filipe; Pires, V. Fernão; Chaves, Miguel; Foito, Daniel; Gamboa, PauloThis paper presents a solar photovoltaic panel simulator system with the ability to perform automatic tests in different condition according to manufacture parameters. This simulator is based on three buck--boost DC -DC converters controlled by a microcontroller and supported by a AXC 1050 Programmable Logic Controller from Phoenix Contact which is responsible for running the automatic tests. This solution allows to understand the typical operation of solar photovoltaic panels and MPPT algorithms considering suddenly changes in the irradiation, temperature, or load.